Faculty Bibliography

High rates of aseptic loosening have been reported for microstructured hydroxyapatite-coated acetabular components. A macrostructured component surface (arc-deposition) not only improves resistance to shear forces experienced by the acetabular component and increases initial stability, but also provides channels for bone ingrowth. The purpose of this investigation was to radiographically compare a series of grit-blasted (microstructured) and arc-deposited (macrostructured) hydroxyapatite-coated acetabular components. A minimum 4-year retrospective radiographic analysis of acetabular components was performed on a total of 50 total hip arthroplasties. At 4 years, arc-deposited components were associated with fewer radiolucent lines in all Charnley zones, particularly Charnley zone III. While the 4-year results for arc-deposited hydroxyapatite acetabular components are superior to their microstructured predecessors, long-term results are still unknown

BACKGROUND: Despite the effectiveness of a two-stage exchange protocol for the treatment of deep periprosthetic infection, infection can persist after resection arthroplasty and treatment with antibiotics, leading to a failed second-stage reconstruction. Intraoperative analysis of frozen sections has been shown to have a high sensitivity and specificity for the identification of infection at the time of revision arthroplasty; however, the usefulness of this test at the time of reoperation after resection arthroplasty and treatment with antibiotics is, to our knowledge, unknown. METHODS: The medical records of sixty-four consecutive patients who had had a resection arthroplasty of either the knee (thirty-three patients) or the hip (thirty-one patients) and had had intraoperative analysis of frozen sections of periprosthetic tissue obtained at the time of a second-stage operation were reviewed. The mean interval between the resection arthroplasty and the attempted reimplantation was nineteen weeks. The results of the intraoperative analysis of the frozen sections were compared with those of analysis of permanent histological sections of the same tissues and with those of intraoperative cultures of specimens obtained from within the joint. The findings of the analyses of the frozen sections and the permanent histological sections were considered to be consistent with acute inflammation and infection if a mean of ten polymorphonuclear leukocytes or more per high-power field (forty times magnification) were seen in the five most cellular areas. RESULTS: The intraoperative frozen sections of the specimens from two patients (one of whom was considered to have a persistent infection) met the criteria for acute inflammation. Four patients were considered to have a persistent infection on the basis of positive intraoperative cultures or permanent histological sections. Overall, intraoperative analysis of frozen sections at the time of reimplantation after resection arthroplasty had a sensitivity of 25 percent (detection of one of four persistent infections), a specificity of 98 percent, a positive predictive value of 50 percent (one of two), a negative predictive value of 95 percent, and an accuracy of 94 percent. CONCLUSIONS: A negative finding on intraoperative analysis of frozen sections has a high predictive value with regard to ruling out the presence of infection; however, the sensitivity of the test for the detection of persistent infection is poor

A surgical technique, which uses a transverse osteotomy, for subtrochanteric femoral shortening and derotation in total hip arthroplasty for high-riding developmental dislocation of the hip is described. Anteversion is set by rotating the osteotomy fragments, and torsional stability is augmented with allograft struts and cables when indicated. Eight patients with 9 total hip arthroplasties were followed for an average of 43 months (range, 24-84 months). Good to excellent results were obtained in 87% of patients (7 of 8). Eight of 9 osteotomies (89%) demonstrated radiographic evidence of healing at an average of 5 months. One patient had an asymptomatic nonunion of the osteotomy site but still had a good overall clinical result. Another patient suffered fatigue failure of a distally ingrown porous device, which necessitated revision total hip arthroplasty 18 months after surgery. Subtrochanteric osteotomy in total hip arthroplasty for developmental dislocation of the hip allows for acetabular exposure and diaphyseal shortening while facilitating femoral derotation. Furthermore, proximal femoral bone stock is maintained and some of the potential complications of greater trochanteric osteotomy may be avoided.

This paper reports on a case of hip joint sepsis complicated by a ruptured appendix in an intravenous drug user. A 41-year-old woman underwent open irrigation and debridement of her right hip joint for a methicillin-sensitive Staphylococcus aureus infection. Five days later the patient developed an intraperitoneal mass, requiring laparotomy and debridement of a periappendiceal abscess. The organisms infecting the abscess were different from those infecting the patient's hip. The patient recovered satisfactorily after 6 weeks of intravenous antibiotic therapy.

Mechanical tests were performed to characterize the initial stability of press-fit cups as a function of cup design, surface structure, and surgical preparation. Eight cups from six manufacturers were press-fit into acetabular cavities prepared in two densities of Sawbones polyethylene foam and in bovine knee trabecular bone. Cavity sizes and cup loading forces were varied. Acetabular defects were simulated in the Sawbones model. Preparations were tested to determine axial-rotatory and tangential ('levering-out') stability. Results suggested that cup geometry and proper surgical technique--in particular, proper sizing and depth of the acetabular cavity--are important in determining initial cup stability independent of adjuvant screw or spike fixation. Stability is a function of the area of interface contact between the cup rim and the substrate. If the cavity is too small or too shallow, and the substrate too dense, the cup will not seat to the rim and stability will be compromised. If there are defects in the rim, the area of interface contact will be diminished and stability compromised. Cups with a true hemispherical design have a greater area of rim interface contact than 'low-profile' cups and are therefore more stable. 1 mm undersizing of the cavity (or 2 mm undersizing in less dense substrate) appears to provide optimal stability