Faculty Bibliography

BACKGROUND:Chronic prosthetic joint infection (PJI) is most frequently treated with 2-stage revision in conjunction with antibiotic treatment. The aims of this study were 1) to investigate the characteristics of patients who have recurrent infection following 2-stage revision for PJI and 2) to identify risk factors associated with treatment failure. METHODS:A multicenter retrospective review of 90 total knee arthroplasty (TKA) patients who underwent 2-stage revision for treatment of PJI from March 1, 2003 to July 31, 2019, and had recurrent PJI was conducted. The minimum follow-up was 12 months (median follow up of 2.4 years). Microorganisms, subsequent revision, PJI control status, and final joint status were collected. The infection-free survival after initial 2-stage revision was plotted utilizing the Kaplan-Meier method. RESULTS:Mean survival time to reinfection was 21.3 months (range, 0.3 to 160.5). There were 14 recurrent infections that were acute PJIs treated with debridement, antibiotics, and implant retention (DAIR), while 76 were chronic and treated with repeat 2-stage revision. The most common pathogen identified for both index and recurrent PJI was coagulase-negative Staphylococci. Pathogen persistence was observed in 14 (22.2%) of recurrent PJIs. In total, 61 (67.8%) patients possessed a prosthetic reimplantation at their most recent follow-up, and 29 (35.6%) patients required intervention following repeat 2-stage. CONCLUSION/CONCLUSIONS:Overall, 31.1% of the patients obtained infection control after treatment of a failed 2-stage revision due to PJI. The high rate of pathogen persistence and the relatively low survival time to recurrence suggests a need to more closely monitor PJIs cases within 2 years.

INTRODUCTION/BACKGROUND:Operating room air quality can be affected by several factors including temperature, humidity, and airborne particle burden. Our study examines the role of operating room (OR) size on air quality and airborne particle (ABP) count in primary total knee arthroplasty (TKA). MATERIALS AND METHODS/METHODS:We analyzed all primary, elective TKAs performed within two ORs measuring 278 sq ft. (small) and 501 sq ft. (large) at a single academic institution in the United States from April 2019 to June 2020. Intraoperative measurements of temperature, humidity, and ABP count were recorded. p values were calculated using t test for continuous variables and chi-square for categorical values. RESULTS:91 primary TKA cases were included in the study, with 21 (23.1%) in the small OR and 70 (76.9%) in the large OR. Between-groups comparisons revealed significant differences in relative humidity (small OR 38.5% ± 7.24% vs. large OR 44.4% ± 8.01%, p = 0.002). Significant percent decreases in ABP rates for particles measuring 2.5 μm (- 43.9%, p = 0.007) and 5.0 μm (- 69.0%, p = 0.0024) were found in the large OR. Total time spent in the OR was not significantly different between the two groups (small OR 153.09 ± 22.3 vs. large OR 173 ± 44.6, p = 0.05). CONCLUSIONS:Although total time spent in the room did not differ between the large and small OR, there were significant differences in humidity and ABP rates for particles measuring 2.5 μm and 5.0 μm, suggesting the filtration system encounters less particle burden in larger rooms. Larger studies are required to determine the impact this may have on OR sterility and infection rates.

BACKGROUND/UNASSIGNED:Total knee arthroplasty (TKA) procedures are expected to grow exponentially in the upcoming years, highlighting the importance of identifying preoperative risk factors that predispose patients to poor outcomes. The present study sought to determine if preoperative healthcare events (PHEs) influenced outcomes following TKA. METHODS/UNASSIGNED:This was a retrospective review of all patients who underwent TKA at a single institution from June 2011 to April 2022. Patients who had a PHE within 90 days of surgery, defined as an emergency department visit or hospital admission, were compared to patients with no history of PHE. Patients who underwent revision, nonelective, and/or bilateral TKA were excluded. Chi-squared analysis and independent sample t-tests were used to determine significant differences between demographic variables. All significant covariates were included in binary logistic regressions used to predict discharge disposition, 90-day readmission, and 1-year revision. RESULTS/UNASSIGNED: = .004) compared to patients without a PHE. CONCLUSIONS/UNASSIGNED:Our results demonstrate that PHEs put patients at significantly greater risk of facility discharge, 90-day readmission, and 1-year revision. Moving forward, consideration of elective surgery scheduling in the context of a recent PHE may lead to improved postoperative outcomes. LEVEL III EVIDENCE/UNASSIGNED:Retrospective Cohort Study.

Reducing pain and opioid consumption after total knee arthroplasty (TKA) is an important perioperative consideration. Though commonly used, the combined influence of tourniquets and adductor canal blocks (ACBs) on pain and opioid consumption is unknown. This study evaluated inpatient opioid consumption and pain between patients with TKA based on tourniquet and/or ACB use. Pain and opioid consumption were highest when a tourniquet, but no ACB was used, and lowest when an ACB, but no tourniquet was used - though absolute differences in pain scores were not clinically significant. Tourniquet and ACB use should be considered as part of TKA opioid-sparing protocols.

BACKGROUND/UNASSIGNED:Surgeons with high volume (HV) of total hip arthroplasty (THA) have seen better outcomes than low volume (LV) surgeons. However, literature regarding surgeon volume and outcomes in morbidly obese THA patients is scarce. This study examines the association between surgeon volume with THA in morbidly obese patients (body mass index ≥40) and their clinical outcomes. METHODS/UNASSIGNED:We retrospectively reviewed all morbidly obese patients who underwent primary THA at our institution between March 2012 and July 2020 with 2 years of follow-up. Clinical outcomes were compared between the HV (HVa, top quartile of surgeons with the highest overall yearly THA volume) and LV (LVa) surgeons. Similar analysis was run comparing HV of morbidly obese THA (HVo, top quartile of surgeons with the highest yearly morbidly obese THA volume) and LV of morbidly obese THA (LVo) surgeons. RESULTS/UNASSIGNED:Six hundred and forty-three patients and 33 surgeons were included. HVa surgeons had significantly shorter length of stay and increased home discharge. HVa and HVo surgeons had significantly shorter operative times. There were no significant differences in overall 90-day major and minor complications or clinical differences in patient-reported outcomes. Revision rates and freedom from revisions did not differ between groups at 2-year follow-up. CONCLUSIONS/UNASSIGNED:HVa surgeons had significantly lower length of stay and operative times and increased discharge to home. There was no significant decrease in complications or revisions in either comparison model. Complications, revision rates, and patient satisfaction in morbidly obese patients who undergo THA may be independent of surgeon volume.

PURPOSE/OBJECTIVE:Soft tissue balancing is an important step in a total knee procedure, carried out manually, or using an indicator. The purpose of this study was to evaluate our design of 3D printed Balancer, and demonstrate how it could be used at surgery. PROCEDURES/METHODS:When inserted between the femur and tibia, the Balancer displayed the forces acting across the lateral and medial compartments, indicated by pointers at the end of the handle. A loading rig was used to measure the pointer deflections for different forces applied at different locations on the condyle surfaces. Repeatability and reproducibilty were evaluated. The Balancer was tested in six fresh knee specimens using a surgical simulation rig. MAIN FINDINGS/RESULTS:Pointer deflections of up to 12 millimeters occurred for less than 1 mm displacements at the condyle surfaces. Reproducibility tests showed a standard deviation of 14% at lower loads, reducing to only 4% at higher loads. Mean pointer deflections were within 8% for forces applied at ±10 mm AP, and +5/-3 mm in an ML direction, relative to the neutral contact point. In specimens, most lateral to medial force differences could be corrected by a 2° change in frontal plane angle of the tibial resection. Effects of ligament releases were also demonstrated. PRINCIPAL CONCLUSIONS/CONCLUSIONS:The 3D printed Balancer was easy to use, and provided the surgeon with lateral and medial force data over a full range of flexion, enabling possible corrective procedures to be specified.

BACKGROUND:Total hip arthroplasty is a common surgical treatment for elderly patients with osteoporosis, particularly in postmenopausal women. In such cases, highly porous acetabular components are a favorable option in achieving osseointegration. However, further discussion is needed if use of such acetabular components is justified under the condition of normal bone mass. AIM/OBJECTIVE:To determine the features of osseointegration of two different types of titanium implants [3-dimensional (3D)-printed and plasma-coated titanium implants] in bone tissue of a distal metaphysis in a rat femur model. METHODS:This study was performed on 20 white male laboratory rats weighing 300-350 g aged 6 mo. Rats were divided into two groups of 10 animals, which had two different types of implants were inserted into a hole defect (2 × 3 mm) in the distal metaphysis of the femur: Group I: 3D-printed titanium implant (highly porous); Group II: Plasma-coated titanium implant. After 45 and 90 d following surgery, the rats were sacrificed, and their implanted femurs were extracted for histological examination. The relative perimeter (%) of bone trabeculae [bone-implant contact (BIC%)] and bone marrow surrounding the titanium implants was measured. RESULTS:= 0.049) compared to the relative perimeter of bone marrow in group II. CONCLUSION/CONCLUSIONS:The use of a highly porous titanium implant, manufactured with 3D printing, for acetabular components provides increased osseointegration compared to a plasma-coated titanium implant.

Total knee arthroplasty (TKA) in the setting of a previous ipsilateral hip fusion/arthrodesis is an uncommon and challenging procedure. There is little information available in the literature on the challenges and techniques available to perform TKA in these patients. For a traditional TKA procedure, the patient is placed in the supine position and various knee-positioning devices are used to allow for adequate knee and hip flexion, which is required for surgical exposure and tibia preparation. Ipsilateral hip arthrodesis presents two major challenges: (1) Hip flexion is crucial for adequate knee flexion while the patient is supine during the TKA procedure, and (2) the use of advanced technology, specifically computer navigation and robotic-assisted surgery techniques, is limited due to the inability to acquire the hip center of rotation during surgery, due to the lack of hip motion. Therefore, equipment and positioning must be adjusted by the surgeon to facilitate TKA in these patients. This article reports the case of a 72-year-old male patient with a long-standing, painless right hip arthrodesis, presenting with end-stage osteoarthritis of the right knee, leg-length discrepancy, and an 11.6° difference between the mechanical and anatomical axes of the femur. We describe the unique surgical planning as well as the surgical positioning options that allow for adequate knee flexion and proper surgical exposure. Furthermore, we describe a novel method of computer-assisted navigation for intra-operative planning and execution utilizing a reflected tibia as a template for the distal femoral cut.

INTRODUCTION/BACKGROUND:The direct anterior approach (DAA) has become increasingly more popular for total hip arthroplasty (THA). Critics of the DAA maintain that a higher complication rate exists; however, data collection is prone to bias as the outcome is collected by the surgeons performing either an anterior or posterior approach (PA). This study aims to compare the short-term outcomes, including complication rates, in a Medicare population between THAs performed via DAA and PA. MATERIALS AND METHODS/METHODS:Baseline patient data was obtained from our institution's database for bundled payments, an unbiased collection source. A retrospective chart review was conducted on 492 Medicare patients who underwent primary THA between October 2016 and September 2017 to separate patients into DAA and PA cohorts. Descriptive patient characteristics along with surgical and clinical data were collected. Statistical tests for significance were based on either t-tests or chi-squared. To control for demographic variables, a multivariable regression analysis was conducted. RESULTS:Two hundred forty-one patients were included in the DAA cohort while 251 were included in the PA cohort. Surgical time (74.39 vs. 103.03 minutes; p < 0.001) and length-of-stay (1.29 vs. 2.74 days; p < 0.001) in patients who underwent the DAA was revealed to be statistically lower compared to the PA cohort. Patients in the DAA cohort were statistically more likely to be discharged to home health agencies (HHA) or self-care compared to those in the PA cohort (93.4% vs.74.5%; p < 0.001). There were no statistical differences in 90-day readmission rates or morphine milligram equivalents per day between both cohorts. CONCLUSION/CONCLUSIONS:The DAA to THA resulted in shorter surgical time, length-of-stay, and increased likelihood of discharge to HHA or self-care when compared with the PA. There were no differences in opioid consumption and complications leading to 90-day readmission.