Faculty Bibliography

Joint and soft tissue injections may be the only way to differentiate various arthritic disorders, accurately identify a septic joint, and apply focused treatment. Certain considerations can make these injections safer and more effective. This article reviews the principles of diagnostic and therapeutic use of joint and soft tissue injections and makes specific recommendations for common injection sites. Also described are appropriate aseptic techniques for aspirating and injecting joints, bursae, and soft tissue, as well as the judicious use of corticosteroid injections in this age group

There is general agreement that the implant of choice for intertrochanteric fractures is the sliding hip screw (SHS). However, considerable differences of opinion exist as to which plate angle--varying from 130 to 150 degrees--is preferred. Thus far there has been no cadaver-based biomechanical analysis of this problem. To examine these questions, we determined the effect of plate angle on plate strain and proximal medial femoral strain distribution in cadaver femurs fixed with 130, 135, 140, 145, and 150 degrees SHS after experimentally produced stable and unstable intertrochanteric fractures. Twenty-four fresh adult cadaver femurs were assigned randomly to either the 130, 135, 140, 145, or 150 degrees SHS group. Each femur was radiographed and bone mineral density was determined by dual-photon absorptiometry. Multiple-strain gauges were affixed to the femur, with specific focus on the proximal femur and plate. Femurs were loaded at 25 degrees adduction in increments of 70 N from 0 to 1,800 N in a servohydraulic testing machine. Femurs were tested in a progressive manner: (a) intact femur; (b) intact femur with SHS inserted; (c) a stable two-part intertrochanteric fracture reduced with SHS; (d) a four-part fracture with the posteromedial fragment (PMF) reduced anatomically by a lag screw; (e) the same fracture with the PMF rotated 180 degrees and held in place by a lag screw to approximate a 'near-anatomic' reduction; and (f) the same fracture with the PMF discarded. Screw sliding measurements were determined at regular intervals throughout each test.(ABSTRACT TRUNCATED AT 250 WORDS)

Ferric hydroxide macroaggregates (FHMA) have been widely used as a carrier for several radionuclides used in radiation synovectomy. Different rates of extra-articular leakage of radioactivity have been observed with 90Y and 165Dy. In order to understand the mechanism(s) involved in the extra-articular leakage of radioactivity, the in vivo stability of FHMA carrier was studied. Following an injection of [59Fe]Fe-FHMA into the knees of normal rabbits, the cumulative leakage of [59Fe]Fe-FHMA was 2.9% at 5 days and 12.3% at 14 days. More than 60% of this activity was in the blood. But when FHMA was double labeled with 59Fe and 166Ho, the 59Fe leakage significantly increased to 18.5% at 5 days and 27% by 14 days. The instability of FHMA is accelerated when it is complexed with 166Ho and may be due to the 'mass effect' of 166Ho or due to radiolysis induced by high energy beta particles from 166Ho. These results suggest that FHMA is a suitable carrier only for the short lived radionuclides used in synovectomy

Revision of a glenoid component can be difficult in the presence of a humeral component. Removal of the humeral component is generally required, which adds significantly to the difficulty of the procedure and increases the risk of complications. This report describes revision of a loose glenoid component that was greatly facilitated by the presence of a modular humeral component