Faculty Bibliography

We have used multilamellar crystals of the ATP-driven calcium pump from sarcoplasmic reticulum to address the structural effects of calcium binding to the enzyme. They are stacks of disk-shaped two-dimensional crystals. A density map projected along the lipid bilayer was obtained at 9-A resolution by frozen-hydrated electron microscopy. Although only in projection, much more details of the structure were revealed than previously available, especially in the transmembrane region. Quantitative comparison was made with the model obtained from the tubular crystals of this enzyme formed in the absence of calcium. Unexpectedly large differences in conformation were found, particularly in the cytoplasmic domain

In an attempt to better define the parameters governing reconstitution and two-dimensional crystallization of membrane proteins, we have studied Ca2(+)-ATPase from rabbit sarcoplasmic reticulum. This ion pump forms vanadate-induced crystals in its native membrane and has previously been reconstituted at high lipid-to-protein ratios for functional studies. We have characterized the reconstitution of purified Ca2(+)-ATPase at low lipid-to-protein ratios and discovered procedures that produce long, tubular crystals suitable for helical reconstruction. C12E8 (n-dodecyl-octaethylene-glycol monoether) was used to fully solubilize various mixtures of lipid and purified Ca2(+)-ATPase, and BioBeads were then used to remove the C12E8. Slow removal resulted in two populations of vesicles, and the proteoliposome population was separated from the liposome population on a sucrose density gradient. These proteoliposomes had a lipid-to-protein ratio of 1:2, and virtually 100% of molecules faced the outside of vesicles, as determined by fluorescein isothiocyanate labeling. Cycles of freeze-thaw caused considerable aggregation of these proteoliposomes, and, if phosphatidyl ethanolamine and phosphatidic acid were included, or if the bilayers were doped with small amounts of C12E8, vanadate-induced tubular crystals grew from the aggregates. Thus our procedure comprised two steps-reconstitution followed by crystallization-allowing us to consider mechanisms of bilayer formation separately from those of crystallization and tube formation

Electron microscopy is gradually revealing more and more about the structure of the calcium pump from the sarcoplasmic reticulum, Ca(2+)-ATPase. The most recent result reveals the ATP-binding site, and two different avenues are being pursued towards achieving a higher resolution structure. Although no such structures are currently available for phospholamban, various spectroscopies and site-directed mutagenesis have been combined to produce a compelling structural model for its regulation of Ca(2+)-ATPase

The location of the ATP-binding site of a P-type ion pump, Ca(2+)-ATPase from rabbit sarcoplasmic reticulum, was examined by cryoelectron microscopy. A nonhydrolyzable analog of ATP, beta, gamma-bidentate chromium (III) complex of ATP (CrATP), was used to stabilize the enzyme in the Ca(2+)-occluded state. Tubular crystals were then induced by vanadate in the presence of EGTA, keeping CrATP bound to the enzyme. The three-dimensional structures of the crystals were determined at 14 A resolution by cryoelectron microscopy and helical image analysis. Statistical comparison of the structures with and without CrATP showed clear and significant differences at the groove proposed previously as the ATP-binding pocket

Regulation of calcium transport by sarcoplasmic reticulum provides increased cardiac contractility in response to beta-adrenergic stimulation. This is due to phosphorylation of phospholamban by cAMP-dependent protein kinase or by calcium/calmodulin-dependent protein kinase, which activates the calcium pump (Ca2+-ATPase). Recently, direct phosphorylation of Ca2+-ATPase by calcium/calmodulin-dependent protein kinase has been proposed to provide additional regulation. To investigate these effects in detail, we have purified Ca2+-ATPase from cardiac sarcoplasmic reticulum using affinity chromatography and reconstituted it with purified, recombinant phospholamban. The resulting proteoliposomes had high rates of calcium transport, which was tightly coupled to ATP hydrolysis (approximately 1.7 calcium ions transported per ATP molecule hydrolyzed). Co-reconstitution with phospholamban suppressed both calcium uptake and ATPase activities by approximately 50%, and this suppression was fully relieved by a phospholamban monoclonal antibody or by phosphorylation either with cAMP-dependent protein kinase or with calcium/calmodulin-dependent protein kinase. These effects were consistent with a change in the apparent calcium affinity of Ca2+-ATPase and not with a change in Vmax. Neither the purified, reconstituted cardiac Ca2+-ATPase nor the Ca2+-ATPase in longitudinal cardiac sarcoplasmic reticulum vesicles was a substrate for calcium/calmodulin-dependent protein kinase, and accordingly, we found no effect of calcium/calmodulin-dependent protein kinase phosphorylation on Vmax for calcium transport

Electron microscopy of multilamellar crystals of CA(2+)-ATPase currently offers the best opportunity for obtaining a high-resolution structure of this ATP-driven ion pump. Under certain conditions small, wormlike crystals are formed and provide views parallel to the lamellar plane, from which parameters of lamellar stacking can be directly measured. Assuming that molecular packing is the same, data from these views could supplement those obtained by tilting large, thin platelike crystals. However, we were surprised to discover that the lamellar spacing was variable and depended on the amount of glycerol present during crystallization (20% versus 5%). Projection maps (h,0,l) from these womklike crystals suggest different molecular contacts that give rise to the different lamellar spacings. Based on an orthogonal projection map (h,k,0) from collapsed, wormlike crystals and on x-ray powder patterns, we conclude that molecular packing within the lamellar plane is the same as that in thin, platelike crystals and is unaffected by glycerol. Finally, the orientation of molecules in the lamellar plane was characterized from freeze-dried, shadowed crystals. Comparing the profile of molecules in these multilamellar crystals with that previously observed in helical tubes induced by vanadate gives structural evidence of the conformational change that accompanies binding of calcium of Ca(2+)-ATPase

Obtaining large, flat, well ordered crystals represents the key to structure determination by electron crystallography. Multilamellar crystals of Ca(2+)-ATPase are a good candidate for this methodology, and we have optimized methods of crystallization and of preparation for cryoelectron microscopy. In particular, high concentrations of glycerol were found to prevent nucleation and to reduce stacking; thus, by seeding solutions containing 40% glycerol, we obtained thin crystals that were 5-30 microns in diameter and 2-10 unit cells thick. We found that removing vesicles and minimizing concentrations of divalent cations were critical to preparing flat crystals in the frozen-hydrated state. Finally, we developed two methods for determining the number of lamellae composing individual crystals, information that is required for structure determination of this crystal form. The first method, using low magnification images of freeze-dried crystals, is more practical in our case. Nevertheless, the alternative method, involving analysis of Laue zones from electron diffraction patterns of slightly tilted crystals, may be of general use in structure determination from thin, three-dimensional crystals