Faculty Bibliography

Desmosomes are a complex assembly of protein molecules that form at the cell surface and mediate cell-cell adhesion. Much is known about the composition of desmosomes and there is an established consensus for the location of and interactions between constituent proteins within the assembly. Furthermore, X-ray crystallography has determined atomic structures of isolated domains from several constituent proteins. Nevertheless, there is a lack of understanding about the architecture of the intact assembly and the physical principles behind the adhesive strength of desmosomes therefore remain vague. We have used electron tomography to address this problem. In previous work, we investigated the in situ structure of desmosomes from newborn mouse skin preserved by freeze-substitution and imaged in resin-embedded thin sections. In our present work, we have isolated desmosomes from cow snout and imaged them in the frozen unstained state. Although not definitive, the resulting images provide support for the irregular groupings of cadherin molecules seen previously in mouse skin

Since the development of three-dimensional helical reconstruction methods in the 1960's, advances in Fourier-Bessel methods have facilitated structure determination to near-atomic resolution. A recently developed iterative helical real-space reconstruction (IHRSR) method provides an alternative that uses single-particle analysis in conjunction with the imposition of helical symmetry. In this work, we have adapted the IHRSR algorithm to work with frozen-hydrated tubular crystals of P-type ATPases. In particular, we have implemented layer-line filtering to improve the signal-to-noise ratio, Wiener-filtering to compensate for the contrast transfer function, solvent flattening to improve reference reconstructions, out-of-plane tilt compensation to deal with flexibility in three dimensions, systematic calculation of Fourier shell correlations to track the progress of the refinement, and tools to control parameters as the refinement progresses. We have tested this procedure on datasets from Na(+)/K(+)-ATPase, rabbit skeletal Ca(2+)-ATPase and scallop Ca(2+)-ATPase in order to evaluate the potential for sub-nanometer resolution as well as the robustness in the presence of disorder. We found that Fourier-Bessel methods perform better for well-ordered samples of skeletal Ca(2+)-ATPase and Na(+)/K(+)-ATPase, although improvements to IHRSR are discussed that should reduce this disparity. On the other hand, IHRSR was very effective for scallop Ca(2+)-ATPase, which was too disordered to analyze by Fourier-Bessel methods

Barth syndrome (BTHS) is a mitochondrial disorder that is caused by mutations in the tafazzin gene, which affects phospholipid composition. To determine whether this defect leads to alterations in the internal three-dimensional organization of mitochondrial membranes, we applied electron microscopic tomography to lymphoblast mitochondria from BTHS patients and controls. Tomograms were formed from 50 and 150 nm sections of chemically fixed lymphoblasts and the data were used to manually segment volumes of relevant structural details. Normal lymphoblast mitochondria contained well-aligned, lamellar cristae with slot-like junctions to the inner boundary membrane. In BTHS, mitochondrial size was more variable and the total mitochondrial volume per cell increased mainly due to clusters of fragmented mitochondria inside nuclear invaginations. However, mitochondria showed reduced cristae density, less cristae alignment, and inhomogeneous cristae distribution. Three-dimensional reconstruction of BTHS mitochondria revealed zones of adhesion of the opposing inner membranes, causing obliteration of the intracrista space. We found small isolated patches of adhesion as well as extended adhesion zones, resulting in sheets of collapsed cristae packaged in multiple concentric layers. We also found large tubular structures (diameter 30-150 nm) that appeared to be derivatives of the adhesion zones. The data suggest that mitochondrial abnormalities of BTHS involve adhesions of inner mitochondrial membranes with subsequent collapse of the intracristae space

Desmosomes are cell-cell junctions responsible for maintaining the structural integrity of tissues by resisting shear forces. Defects result in diseases of mechanically challenged tissues such as skin and heart. The architectural design represents the key to understanding the strength and durability inherent to desmosomes. A number of different proteins contribute to this architecture, and X-ray crystallography has made considerable progress in defining the atomic structure of various isolated domains. Electron tomography has been used to determine the three-dimensional structure of intact desmosomes in situ. By combining information from X-ray crystallography, cell and molecular biology and electron tomography, it should ultimately be possible to deduce the specific protein interactions that define the mechanical properties of this important adhesive junction

Electron microscopy of two-dimensional (2D) crystals has demonstrated potential for structure determination of membrane proteins. Technical limitations in large-scale crystallization screens have, however, prevented a major breakthrough in the routine application of this technology. Dialysis is generally used for detergent removal and reconstitution of the protein into a lipid bilayer, and devices for testing numerous conditions in parallel are not readily available. Furthermore, the small size of resulting 2D crystals requires electron microscopy to evaluate the results and automation of the necessary steps is essential to achieve a reasonable throughput. We have designed a crystallization block, using standard microplate dimensions, by which 96 unique samples can be dialyzed simultaneously against 96 different buffers and have demonstrated that the rate of detergent dialysis is comparable to those obtained with conventional dialysis devices. A liquid-handling robot was employed to set up 2D crystallization trials with the membrane proteins CopA from Archaeoglobus fulgidus and light-harvesting complex II (LH2) from Rhodobacter sphaeroides. For CopA, 1 week of dialysis yielded tubular crystals and, for LH2, large and well-ordered vesicular 2D crystals were obtained after 24 h, illustrating the feasibility of this approach. Combined with a high-throughput procedure for preparation of EM-grids and automation of the subsequent negative staining step, the crystallization block offers a novel pipeline that promises to speed up large-scale screening of 2D crystallization and to increase the likelihood of producing well-ordered crystals for analysis by electron crystallography

Phospholamban (PLB) physically interacts with Ca(2+)-ATPase and regulates contractility of the heart. We have studied this interaction using electron microscopy of large two-dimensional co-crystals of Ca(2+)-ATPase and the I40A mutant of PLB. Crystallization conditions were derived from those previously used for thin, helical crystals, but the addition of a 10-fold higher concentration of magnesium had a dramatic effect on the crystal morphology and packing. Two types of crystals were observed, and were characterized both by standard crystallographic methods and by electron tomography. The two crystal types had the same underlying lattice, which comprised antiparallel dimer ribbons of Ca(2+)-ATPase molecules previously seen in thin, helical crystals, but packed into a novel lattice with p22(1)2(1) symmetry. One crystal type was single-layered, whereas the other was a flattened tube and therefore double-layered. Additional features were observed between the dimer ribbons, which were substantially farther apart than in previous helical crystals. We attributed these additional densities to PLB, and built a three-dimensional model to show potential interactions with Ca(2+)-ATPase. These densities are most consistent with the pentameric form of PLB, despite the use of the presumed monomeric I40A mutant. Furthermore, our results indicate that this pentameric form of PLB is capable of a direct interaction with Ca(2+)-ATPase

CopA from the extreme thermophile Archaeoglobus fulgidus is a P-type ATPase that transports Cu(+) and Ag(+) and has individual metal-binding domains (MBDs) at both N- and C-termini. We expressed and purified full-length CopA as well as constructs with MBDs deleted either individually or collectively. Cu(+) and Ag(+)-dependent ATPase assays showed that full-length CopA had submicromolar affinity for both ions, but was inhibited by concentrations above 1muM. Deletion of both MBDs had no effect on affinity but resulted in loss of this inhibition. Individual deletions implicated the N-terminal MBD in causing the inhibition at concentrations >1muM. Rates of phosphoenzyme decay indicated that neither the dephosphorylation step, nor the E1P-E2P equilibrium accounted for this inhibition, suggesting the involvement of a different catalytic step. Alternative hypotheses are discussed by which the N-terminal MBD could influence the catalytic activity of CopA

Interactions between the transmembrane domains of phospholamban (PLB) and the cardiac Ca2+ pump (SERCA2a) have been investigated by chemical cross-linking. Specifically, C-terminal, transmembrane residues 45-52 of PLB were individually mutated to Cys, then cross-linked to V89C in the M2 helix of SERCA2a with the thiol-specific cross-linking reagents Cu2+-phenanthroline, dibromobimane, and bismaleimidohexane. V49C-, M50C-, and L52C-PLB all cross-linked strongly to V89C-SERCA2a, coupling to 70-100% of SERCA2a molecules. Residues 45-48 and 51 of PLB also cross-linked to V89C of SERCA2a, but more weakly. Evidence for the mechanism of PLB regulation of SERCA2a was provided by the conformational dependence of cross-linking. In particular, the required absence of Ca2+ for cross-linking implicated the E2 conformation of SERCA2a, and its enhancement by ATP confirmed E2 x ATP as the conformation with the highest affinity for PLB. In contrast, E2 phosphorylated with inorganic phosphate (E2P) and E2 inhibited by thapsigargin (E2 x TG) both failed to cross-link to PLB. These results with transmembrane PLB residues are completely consistent with cytoplasmic PLB residues studied previously, suggesting that the dissociation of PLB from the Ca2+ pump is complete, not partial, when the pump binds Ca2+ (E1 x Ca2) or adopts the E2P or E2 x TG conformations. V49C of PLB cross-linked to 100% of SERCA2a molecules, suggesting that this residue might have functional importance for regulation. Indeed, we found that mutation of Val49 to smaller side-chained residues V49A or V49G augmented PLB inhibition, whereas mutation to the larger hydrophobic residue, V49L, prevented PLB inhibition. A model for the interaction of PLB with SERCA2a is presented, showing that Val49 fits into a constriction at the lumenal end of the M2 helix of SERCA, possibly controlling access of PLB to its binding site on SERCA

Surface-enhanced Raman scattering (SERS) spectroscopy is a plasmonics-based spectroscopic technique that combines modern laser spectroscopy with unique optical properties of metallic nanostructures, resulting in strongly increased Raman signals when molecules are adsorbed on or near nanometer-size structures of special metals such as gold, silver, and transition metals. This chapter provides a synopsis of the development and application of SERS-active metallic nanostructures, especially for the analysis of biologically relevant compounds. Some highlights of this chapter include reports of SERS as an immunoassay readout method, SERS gene nanoprobes, near-field scanning optical microscopy SERS probes, SERS as a tool for single-molecule detection, and SERS nanoprobes for cellular studies