Faculty Bibliography

The effect of three types of fluoride dentifrices and one non-fluoride dentifrice were evaluated and compared intra-orally for their ability to promote the remineralization of caries-like lesions in thin sections of human dentin and enamel. The three fluoride dentifrices were silica based. One dentifrice contained 0.76% sodium monofluorophosphate (MFP), another contained 0.247% sodium fluoride (NaF), and the third contained 0.247% NaF plus 1.3% pyrophosphate and 1.5% polyvinylmethyl ether/maleic acid (PVM/MA) copolymer (denoted NaF/PPi). The fourth dentifrice (placebo) was also silica based, but contained no fluoride, and served as a negative control. Two week treatment resulted in the following percent mineral changes for the enamel specimens: +21 +/- 16 for MFP, +10 +/- 30 for NaF, +16 +/- 15 for NaF/PPi, and -30 +/- 30 for the placebo. The respective percent mineral change values for the dentin specimens were +28 +/- 20 for MFP, +22 +/- 19 for NaF, +28 +/- 18 for NaF/PPi, and -34 +O/- 61 for the placebo. A statistical analysis revealed that the three fluoride dentifrices were significantly better (p<0.05) than the placebo at promoting remineralization for both types of specimens. No significant differences were found among the three fluoride dentifrices. The following can be concluded from this study: 1) silica based dentifrices containing MFP and NaF are effective at remineralizing caries-like lesions in both enamel and dentin; 2) there was no statistical difference between NaF and MFP in their ability to promote remineralization; and 3) pyrophosphate does not interfere with the remineralizing effects of NaF.

This study investigated whether commercially available mouthwashes could affect or change the color of a hybrid composite resin. Twenty-four disks were fabricated and divided into eight equal groups for testing. At baseline, six colorimetric recordings and color parameters (L*, a*, b*) were recorded for each grouping of disks using a Chroma Meter CR-300 in reflectance mode. The groups of disks were immersed in their respective mouthwashes for 2 minutes a day in a vibratory fashion over a 6-month period. At the end of 6 months, color differences, delta E, were calculated between the base line and test recordings. The results indicate that rinsing with mouthwashes for 6 months can cause a hybrid resin to undergo color variations. Except for one product the color variations were not clinically significant

This study evaluated the effects of alcohol-containing mouthwashes on composite resin hardness. Eighty hybrid composite discs were fabricated and divided into eight equal groups: Listerine, Scope, Viadent, Plax, Lavoris, Clear Choice, and Rembrandt Mouth Refreshing Rinse. Water acted as a control. All of the discs were immersed by group in their respective liquids for two minutes a day over a period of six months. Disc hardness was measured six times at the center and periphery using a Barcol impressor. The baseline values were taken for each disc and compared to the test values at the end of six months. The results of the study indicate that the alcohol content in mouthwashes can affect composite hardness. This softening affect can be directly related to the percentage of alcohol in the mouthwash

This in vitro study evaluated the abrasiveness of seven dentifrices on microfill composite resin discs and dentin surfaces. The composite resin discs and dentin surfaces were brushed in groups using slurries of the different dentifrices. Each specimen was subjected to 2400 strokes using medium bristle toothbrushes at a brush tension of 150 g. Any changes in surface roughness were noted through the use of a mechanical profiler or profileometer and scanning electron micrographs. The results of this study have indicated that Rembrandt Whitening Toothpaste was significantly less abrasive to the microfill composite discs and dentin surfaces compared to the other dentifrices tested (p < .05, ANOVA). Further clinical studies may be warranted to test the abrasiveness of dentifrices, especially if they are used over extended periods of time

The purpose of this scanning electron microscope study was to observe the interface between dentin and amalgam utilizing various adhesive resin cements. The adhesive resin materials used in this study were Imperva Dual, Geristore, and Panavia. The scanning electron micrographs revealed that bonds were established between amalgam, adhesive resins, and dentin

This study was to determine the shear bond strengths of Ni-Cr alloy to Ni-Cr alloy (Group I), Ni-Cr alloy to enamel (Group II), and Ni-Cr alloy to dentin (Group III) using Imperva Dual, DC Metabond, All-Bond, Geristore, and Panavia. All bonded specimens were thermocycled 2000 x (5 degrees C-55 degrees C) after 24 hours and subjected to shear bond testing on a Universal Instron Testing Machine. In all groups of the study, Imperva Dual and CB Metabond had significantly (p < .05) higher bond values than Panavia